SN 420 NEWTON

SN 420 NEWTON

2 Speed Three-phase (V 400 – 50 Hz, other voltages upon request)

  • Please enter your full name
  • Please enter your phone number including STD code
  • Please enter your email address for corespondence
  • Please enter your company name
  • Please enter your postcode
  • Please indicate your preferred method for us to reply by.
  • Please indicate the areas of interest.
  • Please ask your questions here.
  • Please could you indicate above what method you used to find Accurate.
  • By making this enquiry, you consent to receiving an emailed reply. Please tick the boxes below to indicate that you wish to receive further emails regarding this or similar products. At no point is your information shared with any other company or marketing service.
Category:

Description

 
NEWTON DEVICE DESCRIPTION

  • M – Manual mode: Put the selector in M position (manual). Turn the apposite handwheel so that it matches the index with 0 (zero) indicated on the scale. In this way we tighten the saw balancing contrast spring. Lock the piece by closing the vice. Press the start button and go on with the normal manual cutting cycle: remember that the bow descent is activated only by pressing the start button. It is possible to adjust bow descent pression acting on flow regulator.

 

  • D – Dynamic mode: Put the selector in D position (dynamic). Turn the apposite handwheel so that it matches the index with 40 (forty) indicated on the scale. In this way we loose the sawbalancing contrast spring. Adjust the limit switch at the end of the cut. Lock the piece by closing the vice, position the blade above the piece to be cut and press the start button. Now it is possible to adjust bow descent pression by means of the flow regulator: hence the bow go down by gravity autonomously. At the end of the cut the limit switch will stop the blade motion. Raise the bow above the piece and replace the bar to be cut.

 
ACCESSORIES UPON REQUEST:

  • Micromist lubrication
  • MRP pneumatic quick clamp kit
  • Laser cutting indicator
  • Mechanical speed variator
  • Loading & unloading conveyors

 
DIMENSIONS > 870 x 1860 x 2100 mm

WORKTOP HEIGHT > 955 mm

WEIGHT > 550 kg

 

Cutting capacity

 
> Round tubes
45° sx: 170 mm

0: 280 mm

45° dx: 230 mm

60°: 150 mm

> Square profiles
45° sx: 150 mm

0: 270 mm

45° dx: 220 mm

60°: 150 mm

> Rectangular profiles
45° sx: 240 x 90 mm

0: 420 x 190 mm

45° dx: 230 x 150 mm

60°: 140 x 220 mm

Related products