SN 300 SA

SN 300 SA IDR bandsaw

SEMIAUTOMATIC BAND SAW
2 Speed Three-phase (V 400 – 50 Hz, other voltages upon request)

  • Please enter your full name
  • Please enter your phone number including STD code
  • Please enter your email address for corespondence
  • Please enter your company name
  • Please enter your postcode
  • Please indicate your preferred method for us to reply by.
  • Please indicate the areas of interest.
  • Please ask your questions here.
  • Please could you indicate above what method you used to find Accurate.
  • By making this enquiry, you consent to receiving an emailed reply. Please tick the boxes below to indicate that you wish to receive further emails regarding this or similar products. At no point is your information shared with any other company or marketing service.
Category:

Description

 
MAIN FEATURES

All main machine components are in cast iron. Very robust structure reduces noise level and vibrations during cutting cycle.

  • Motor is in vertical positionto reduce dimensions at rear, the transmission is made by means of a worm drive gearbox in oil bath (1:40 ratio).
  • Large circular support base: it offers an ample surface to support piece during cutting cycle and allows to reach a high grade of precision in cutting perpendicularity. It rotates over a tempered ball track giving maximum smoothness during rotation.
  • Adjustable bow positionby means of a key on eccentric bushing for 90° cuts, by means of mechanical stops at 45° right & 45-60° left.
  • Blade guides: they drive the blade sliding by means of widia hard metal plaques with bearings on eccentric bushings.
  • Hydraulic cylinderfor adjustable vice motion. It can be positioned lengthwise along the entire machine
    base. Vice features: rapid closing, closing hand wheel, flat adjustable gib plate.
  • Retractable and adjustable vice shoulders.Pushing back the retractable vice shoulder, it is possible to reach the maximum cutting capacity (330 x 150 mm, at 90°). The adjustable vice shoulder allow always to obtain a precise alignment.
  • Blade tightening device:this is the best solution for a constant and uniform blade tension.
  • Blade lubrication cooling systemwith electric pump and two adjustable taps placed on blade guides.
  • Control panellocated in an easily accessible position.
  • Blade start switchwith “man present” guard. The safety switch for blade drive is guarded by a cover against accidental start-up. It works in low voltage.
  • Drive pedalfor semiautomatic cutting cycle.
  • The hinged bowis moved on a support with conical bearings.
  • Double emergency push buttonlocated in front of the machine frame for greater safety in case of need.
  • Electronic safety sensorto stop blade motion in case of slippaging or breakage of the same.

 
ACCESSORIES UPON REQUEST:

  • Laser cutting indicator
  • Clamp pressure regulator
  • Micromist lubrication
  • Vertical anti-burr clamp
  • Electronic speed variator
  • Loading & unloading conveyors

 
DIMENSIONS > 1400 x 1500 x 1800 mm

WEIGHT > 490 kg

 

Cutting capacity

 
> Round tubes
45° sx: 160 mm

0: 220 mm

45° dx: 200 mm

60°: 130 mm

> Square profiles
45° sx: 120 mm

0: 190 mm

45° dx: 150 mm

60°: 110 mm

> Rectangular profiles
45° sx: 160 x 130 mm

0: 330 x 150 mm

45° dx: 160 x 130 mm

60°: 110 x 110 mm

Related products